When was the final time the roof of your building was inspected? If it’s been awhile, the roof may have problems lurking that require immediate attention. Some roof problems cause obvious signs such as for example leaks, while others produce subtle signs that are only detectable at first glance. In either case, leaving the problems unaddressed can cost you a small fortune when you finally repair them. If the roof on your own building has any of the problems listed below, a company that focuses on commercial roofing should repair them quickly:
Buckled Panels
Roof panels buckle because of weather damage and poor installation. Whatever the cause, the buckling allows wind to blow within the panels, making them loose. Because the problem worsens, the panels start to fall off, often coming off in large sections when a storm hits. Buckled panels are one of the most commonly fixed problems by companies that perform roof repair.
Expended Screw Holes
Expanded screw holes are another problem for panel roofs. Over time, wind and fluctuating temperatures cause the screw holes in panels to widen around the screws that hold the panels set up. This creates an area where water can leak within the panels and soak the roof deck. Once the deck becomes saturated, the problem is costly to fix.
Blistering
Improper heating procedures and dry lapping cause hot bituminous roof systems to blister. Although small blisters seldom pose a problem, large ones can rupture and invite water to seep under the bitumen. Once the blisters form, warm weather typically makes them worse. Due to the humid subtropical climate in some regions of the united states, commercial roofing frequently experiences blistering.
Ponding Water
Blocked drains and improper sloping can cause water to gather in small ponds on a roof. Repairing Soft wash roof cleaning near me blocked drain is easy, but fixing a sloping problem is more technical. Often, installing a taper insulation system to determine a new slope is a good solution. Through the rainy season, resolving ponding water is among the most common types of roof repair.
Loose Flashing
Flashing prevents water from seeping in the crevice where the roof abuts to protrusions such as chimneys and vents. Over time, most flashing must be resealed. If it’s not, leaks could cause serious damage the deck and building interior. Most flashing problems are corrected during the course of scheduled maintenance.
Missing Mortar
Chimneys and high parts of brick walls that have parts of missing mortar could cause leaks. These leaks tend to be mistaken for leaks in the roof membrane, but an intensive inspection by way of a company that specializes in commercial roofing will reveal the real problem. Most sections of missing mortar can be repaired with basic tuck pointing procedures.
Conclusion
The problems above are a few of the most common reasons for roof repair. If they are corrected early, most problems are cheap to fix, but not addressing them until they cause serious problems may necessitate roof replacement. Having a scheduled maintenance agreement with a roofing company is the better way to ensure problems are detected early.
